Prusa Printers

Make sure to use the following settings for PLA. Otherwise, your part may come loose and damage the printer!

  • Nozzle temp: 210 degrees or higher
  • Bed temp: 55 degrees or higher
  • First layer speed: 20 mm/sec
  • Filament diameter: 1.75 mm

Print on a CLEAN BUILD PLATFORM ONLY. Do not use glue stick or hairspray*. This makes the parts hard to get off, and can lead to damage to the printer.

*Glue stick should be used for NinjaFlex only. Use a speed of 20 mm/sec or slower, and clean the bed thoroughly with water after printing.